HVAC Installation in Clifton, AZ
A new system here will heat from October through April and cool from June through September every year. Tell us about the house, and a licensed contractor who covers Greenlee County will get in touch.
Tell us about the job
It takes about a minute.
In Clifton, a new system works most of the year
Winter nights here average 29°F from December through February, and homes need the heat on from October through April, seven months a year. Summer afternoons average 88°F, and the system needs to cool from June through September, four more months. Add it up and it is eleven months when your furnace or air conditioner is doing real work.
Most homes in Greenlee County heat with gas. Whatever you install, it has to handle both ends of the year here, the cold nights and the hot afternoons, with only a short break between the two seasons.
- 7 months
- October through April, your system heats
- 4 months
- June through September, it cools
- 29°F
- the average winter night it heats against
- 88°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Arizona requires HVAC contractors to hold a state license.
The license comes from the Registrar of Contractors, and it belongs to the contractor, not to any single job. It has to be in place before that contractor takes on any installation, this one included, not renewed or checked job by job.
For this job, that license tells you the contractor is the one the state holds accountable. What tells you this particular installation was done right is the permit. Putting in a new furnace, air conditioner or heat pump needs a permit from the local building office in most cities and counties, and an inspection once the work is finished. That inspection is where a bad gas connection or a system set up wrong gets caught, separate from whatever the license already says about the contractor.
Sources: Arizona State Legislature · Arizona Registrar of Contractors
- When should I replace my HVAC system?
- Replace it when repairs get more frequent or the system can't keep up on the coldest or hottest days. A furnace working hard for 7 months a year and an air conditioner covering 4 more takes a lot of cycles, and once a unit is past the age where parts are getting harder to find, another breakdown is usually just around the corner. Rising energy bills with no other explanation are another sign the equipment is losing efficiency. A contractor can look at the age and condition of what you have and tell you whether repair still makes sense or whether you're better off putting that money toward a new system.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, replacing them together is often the better choice, but it depends on the condition of each one. A furnace and air conditioner installed at different times can still work fine independently, so if one is newer and running well, there's no reason to replace it early. What matters is whether the two share a blower or coil setup that limits your options later. A contractor can check how your system is configured and tell you whether pairing the replacement makes sense for your house.
- What happens during an HVAC installation?
- A contractor removes the old equipment, sets the new furnace or air conditioner in place, and connects it to your ducts, gas line or refrigerant lines, and electrical wiring. Once it's connected, they check the airflow, test the thermostat, and confirm the system starts up and shuts down correctly. For a gas furnace, that includes checking the venting so exhaust leaves the house safely. Arizona requires the contractor doing this work to hold a state license through the Registrar of Contractors.