HVAC Repair in Payson, AZ
Homes here need heat from November through April and cooling from June through September. If your system quits, tell us what it's doing and a licensed contractor who covers Gila County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of work, most years
Payson only gets a break from heating or cooling about two months a year. Furnaces run November through April, and nights average 32°F in the coldest stretch, so the burner is cycling on and off most winter evenings. Every start puts a little more wear on the igniter, and when it finally gives out the furnace won't light at all.
Summer afternoons average 92°F, and the air conditioner runs June through September to keep up. That kind of steady load wears on the compressor and can leave a system short on refrigerant, and you'll notice it as air that comes out warm instead of cold. Storms move through here too, with 23 winter storms and 32 damaging wind events recorded over the past ten years. Most systems come back on their own once power returns, but 44% of homes here heat with electricity, so a long outage in the cold months means no heat until the power does.
- 6 months
- November through April, your system heats
- 4 months
- June through September, it cools
- 32°F
- the average winter night it heats against
- 92°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Arizona requires HVAC contractors to hold a state license.
The Registrar of Contractors tests the contractor before granting that license, and keeps a record of who holds one. The license is tied to the person or company doing the work, not to the specific job in front of them, so the same license covers a furnace repair in Payson and a heat pump job in Globe.
For a repair on your heating and cooling system, that license is what stands behind the work. Gas connections are the part worth getting right, since a loose fitting or bad joint is what turns a repair into a hazard, and a licensed contractor is accountable to the Registrar of Contractors if that work is done wrong.
Sources: Arizona State Legislature · Arizona Registrar of Contractors
- Why is my heat not working?
- Start with the thermostat. Check that it is set to heat and set a few degrees above room temperature, and check the batteries if it uses them. If the thermostat looks right, check the breaker for the furnace or air handler and the switch that looks like a light switch near the unit, since either one being off will stop the system cold. A furnace that runs but blows cold air often has a bad igniter or a flame sensor that needs cleaning, and that calls for a contractor. Winters here run November through April, so a furnace that will not start on a 32°F night needs attention the same day.
- Why is my system running but not cooling the house?
- Check the air filter first. A filter clogged with dust blocks airflow across the coil, and the coil can ice over, which means the system runs but the air coming out barely feels cool. Go outside and check the condenser unit too. If the fan is not spinning or the unit is caked in leaves and debris, it cannot move heat out of the house no matter how long it runs. If the filter is clean and the outdoor unit is clear, the problem is likely low refrigerant or a failing part inside the system, and that needs a licensed contractor to diagnose.
- What can I check before calling for HVAC repair?
- Check the thermostat settings, the batteries, and the breaker for the indoor and outdoor units. A tripped breaker or a thermostat switched to the wrong mode causes a lot of no-heat and no-cool calls, and both take a minute to check. Check the air filter next and replace it if it is visibly dirty, since a blocked filter can cause problems that look like bigger failures. If everything there looks fine and the system still is not heating or cooling, that points to something inside the unit, and a licensed contractor will need to look at it. Arizona requires HVAC contractors to hold a state license through the Registrar of Contractors, so ask for that license number before any work starts.